Throttle control | Control bar |
(If equipped) |
|
| ||
| Locknut | |
| ||
screw | Cable | |
or hex bolt | ||
ties | ||
supplied | ||
|
ASSEMBLE STARTER ROPE GUIDE
(USE HARDWARE GROUP “G”)
CENTER MOUNT TYPE
•Install threaded end of rope guide through hole in top of lower handle crossbar.
•Loosely assemble
•Hold control bar against upper handle and slowly pull starter rope out and up over lower handle crossbar and slip into loop of rope guide.
•Push rope guide down against crossbar and tighten nut securely.
Engine starter rope
Rope guide
Lower handle
SIDE MOUNT TYPE
•Put threaded end of rope guide through hole in side of upper handle above lower handle crossbar. Secure with
•Hold control bar against upper handle and slowly pull starter rope out until rope will slip into loop of rope guide.
Control bar
Upper handle
Rope guide
Keps locknut
Lower handle crossbar
Engine starter rope
SPARK PLUG BOOT (IF EQUIPPED)
(NO HARDWARE REQUIRED)
On some model lawn mowers a spark plug boot is packed loose in the parts bag. If your model has one, install it on spark plug wire and then reconnect plug to spark plug.
Spark | Spark |
plug wire | |
plug |
|
Boot
ASSEMBLE GRASS CATCHER
(REAR DISCHARGE MODELS ONLY) (NO HARDWARE REQUIRED)
•Put grass catcher frame into grass bag with rigid part on bottom.
•Slip vinyl bindings over frame. If bind- ings are too stiff, hold them in warm water for a few minutes. Allow bag to dry before using.
Catcher frame
Vinyl binding
| Frame |
15 | opening |