BRIGGS & STRATTON ENGINE SHOWN (Clamp and Screw are preassembled on Tecumseh engines)
QUANTUM ENGINES -
SPARK PLUG TO REAR OF MOWER
Speed lever
Diecast clamp
#10 x 5/8
Hex head screw
Throttle lever
Diecast clamp
Hex Head Screw #10 x 5/8
Throttle cable
BRIGGS & STRATTON CLASSIC AND SPRINT ENGINES WITH THE SPARK PLUG TO FRONT OF MOWER
•Attach throttle cable to side of engine housing with cable clip and #10 x 5/8 hex washer head screw. Tighten securely.
Throttle cable
#10 x 5/8
Hex head screw
Cable clip
MODELS WITH BRIGGS & STRATTON QUANTUM ENGINES
•Slide throttle lever on engine to CHOKE position (away from spark plug). Push gently beyond first stop to lock in detent (CHOKE position).
•Insert wire “Z” bend of throttle cable into throttle lever hole from top side.
•Secure throttle cable to engine with diecast clamp and #10 x 5/8 hex head screw and tighten securely.
QUANTUM ENGINES -
SPARK PLUG TO FRONT OF MOWER
ASSEMBLE ENGINE ZONE CONTROL CABLE TO ENGINE
(NO HARDWARE REQUIRED)
Follow the appropriate instructions below for the brand or type of engine on your lawn mower.
MODELS WITH BRIGGS & STRATTON CLASSIC OR SPRINT ENGINE
Cable attaches under the brake arm cover, which is opposite the spark plug end of engine.
•Straighten cable and find the end with the small plastic fitting.
•Hook the “Z” bend fitting on inner wire of cable into hole in brake arm of engine.
•Align the tapered end of the plastic fitting with the hole in mounting bracket and push in until fitting snaps into place.
•Route cable below crossbar portion of lower handle and up to upper handle control bar.
•Hook “Z” bend fitting on inner wire into hole in control bar (See “ASSEMBLE CABLES TO UPPER HANDLE” in this manual).
Engine cable clip | Brake | Mounting |
(rearward spark plug | arm | bracket |
models only) | cover | Brake |
|
| arm |
Throttle cable
Hex
Head
Screw #10 x 5/8
Diecast clamp
Throttle | Hex head screw #10 x 5/8 | |
lever | ||
(rearward spark plug models only) | ||
|
13