OPERATION
SPARK | ENGINE OIL CAP | AUGER |
PLUG | WITH DIPSTICK | CONTROL |
SAFETY |
| LEVER |
IGNITION |
|
KEY | GASOLINE |
| |
| FILLER |
| CAP |
CHOKE |
|
| CHUTE | |
|
| DEFLECTOR | ||
CON- |
|
| ||
|
|
| ||
TROL |
|
|
| |
|
|
| FUEL | |
|
|
| ||
|
|
| VALVE | |
THROTTLE |
|
|
| |
/ ENGINE |
|
|
| |
CONTROL |
|
| DISCHARGE | |
|
|
| ||
|
|
| CHUTE | |
RECOIL | POWER |
|
| |
(AUXILIARY) |
|
| ||
CORD |
|
| ||
STARTER |
|
| ||
PLUG | ELECTRIC |
| ||
HANDLE | OIL DRAIN PLUG | |||
| ||||
|
| START |
| |
|
| BUTTON | ||
PRIMER |
|
| ||
|
|
|
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
FIG. 10
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED | DEFLECTOR REMOTE |
CONTROL LEVER | CONTROL LEVER |
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
TOOLBOX
FREEWHEEL
CONTROL
DRIFT CUTTER
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox – used to store spare shear bolts, locknuts and | LH and RH turn triggers – used to steer the snow thrower. | |
wrench. | Drive speed control lever – used to select forward or | |
| ||
Safety ignition key - must be inserted for the engine to | reverse motion and speed of snow thrower. | |
start and run. Remove when snow thrower is not in use. | Traction drive control lever – used to engage | |
Electric start button – used for starting the engine. | pelled forward or reverse motion of snow thrower. | |
Recoil (auxiliary) starter handle – used for starting engine. | Auger control lever – used to engage auger motion | |
Primer – pumps additional fuel from the carburetor to the | (throw snow). | |
Discharge chute control lever – used to change the | ||
cylinder for use when starting a cold engine. | ||
Choke Control – used for starting a cold engine. | direction the snow is thrown. | |
Deflector remote control lever – used to change the | ||
Throttle / Engine control – used to select either FAST or | ||
distance the snow is thrown. | ||
SLOW engine speed and to STOP the engine. | ||
Skid plate – used to adjust height of scraper bar from ground. | ||
Freewheel control – disengages transmission for pushing | ||
9 Drift cutter – used to cut through deep snowdrifts. | ||
the snowthrower with the engine off. |
