Mitsubishi Electronics WS-55711 manual Remote Control Functions Channel Selection and Sleep Timer

Remote Control Functions: Channel Selection and Sleep Timer

Channel Selection Sleep Timer

For Ant-A or Ant-B Channels: You have three

options...

•Enter three numbers (for channel 2, press 002).

•Press the channel number and ENTer (for channel 2, press 2, then ENTer).

•Enter the channel number and wait four seconds. The TV will change automatically.

For Ant-DTV Channels

(When Ant-DTV is the current device):

1.Enter two or three numbers for the major channel number. If three numbers are pressed, the separator is automatically added and

you may proceed to step 2. If two numbers are pressed, you must add the separator by pressing the SUB button on the remote control.

2. Enter a 1-digit sub-channel number and wait four seconds. Enter a 1-digit sub-channel number and press ENTer. Or enter 2 digits for this sub-channel and the TV will automatically switch channels.

Remote Control Functions: Operation of PIP and POP

Picture-In-Picture (PIP) and Picture-Outside- Picture (POP) features allow you to view programming in different ways. While watching the main screen, you can display programs from other channels and other inputs. You can display

asingle PIP, side-by-side pictures, three POPs, or nine POPs.

Setting the Sleep Timer:

1.Press SLEEP on the remote control.

Note: A message indicating the length of time the sleep timer is to be set for is displayed on the TV screen.

2.Each press of SLEEP increases the time displayed by 30 minutes, until the maximum value of 120 minutes is reached.

3.After 5 seconds of inactivity, the message will disappear.

4.Press SLEEP to view the remaining time before the timer turns the TV off.

Canceling the Sleep Timer:

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

•POP: side-by-side pictures

•3 POP

•9 POP

•PIP

•PIP/POP: off

To turn PIP/POP off, wait at least 10 seconds, and press

PIP/POP.

Activating the PIP and POP

Figures 1-5 on following page

Press PIP/POP to activate the PIP/POP option. With each press of the PIP/POP button on the TV remote control (within 3 seconds of each other), the PIP/POP will cycle through the following display options.

62