Mitsubishi Electronics WS-B55, ws-65712, WS-65511, WS-65611, WS-65711

Cabinet Separation for Model WS-65712

For Mitsubishi Dealers and Service Personnel Only

The Mitsubishi TV model WS 65712 cabinet is assembled in two pieces. These pieces may be separated to allow for easier delivery and set up. The instructions below show how to safely separate and reattach the cabinet. This TV weighs over 249 lbs and has many sensitive components. This dismantling procedure should be done by authorized Mitsubishi Dealers or Service Personnel only.

4

1

��

3

��

��

��

2

��

��

��

The following operation should be performed by two people.

Follow the procedures for separating the upper and lower sections of the projection TV cabinets as described below:

1.Remove the glossy wood front panel by pulling forward from the left and right sides of the TV.

2. Disconnect the AV jack connector.

3. Remove the decorative plastic cover on each side of the cabinet. Remove the exposed screw on each side.

4.Slide forward the top cabinet then carefully lift the cabinet-top straight up until the brackets are clear from the cabinet-bottom.

5.Carefully place the cabinet-top on to the floor.

6.Once you have have moved and positioned the cabinet-bottom to its desired location, reverse the procedure and mount the cabinet-top on the cabinet-bottom. Be sure you align the brackets properly. Keep fingers clear of all joints! Replace the screws and the decorative plastic covers that were removed in Step 1.

��

��

4

��

��

��

��

��

81

Image 81

Mitsubishi Electronics WS-B55 Cabinet Separation for Model WS-65712, Following operation should be performed by two people

Contents

Owner’s Guide Risk of Electric Shock This Owner’s Guide Important Safeguards Accessories CleaningPower Source Power-Cord Protection Damage Requiring Service Power LinesReplacement Parts Safety Check Consumer Relations This Section Our Thanks Unpacking Your New TV Special FeaturesPage Chapter TWO Power/Timer System ResetReset Front Control Panel Back Panel IEEE-1394 Input/Output Antenna DTV ANT-DTVDigital Audio Output IR Emitter-Home Theater Control Output Receiver Input by Manufacturer Connecting External Devices & NetCommand Setup NetCommand Compatible Legacy Devices NetCommand Supported Devices Separate UHF and VHF Antennas Antenna or Wall Outlet Cable for Digital Broadcasts Cable Box Antenna or Wall Outlet Cable for Analog BroadcastsFor antennas with twin flat lead For cable or antenna with coaxial lead VCR to Analog Antennas or Wall Outlet Cable Figure Connecting an Analog VCRVCR to Cable Box Figure Adding Composite Video or an S-Video with Audio Connections Connecting an A/V Receiver Connecting an Audio/Video Surround Sound Receiver Connecting a DVD Player DVD Player with Component VideoVideo Satellite Receiver DTV Connectors and Adaptors Connecting an External Digital TV DTV or Hdtv ReceiverExternal DTV Receiver with Component Video Connections DTV Receiver/TV Back panel Connecting an External Digital TV TV or HTV Receiver, External DTV Receiver with RGB Video ConnectionsDTV Receiver / TV Back Panel Connecting the IR-Home Theater Control and IR Repeater Connecting a Computer with a VGA Monitor OutputConnecting a Computer Steps 2-4 Apply both 1A and 1B Important Notes Cancel Button Radio Buttons NetCommand Setup Getting StartedButtons Back Button TV Control and NetCommand Programming the Remote Control to Control NetCommand935 Devices NetCommand Setup Language ScreenInformation Screen Receiver Screen NetCommand Setup, cont’dCable Box Screen VCR Screen DBS Screen Camcorder ScreenDVD Screen Finish Screen Review Screen Edit NetCommand Screen Edit NetCommandAdd Change Delete Edit NetCommand, cont’dReview Initial Name Screen RF Connection for Cable ScreenFixed Channel Screen Connection for Device Screen Monitor Out to AVR ScreenMonitor Out to VCR Screen AVR to VCR Connection Screen Input-DTV Connection ScreenIR Code for Device Screen Chapter Three Characters or move one space backward 3D Graphical Menu System Device Selection Menu Power On/Off DevicesAudio Section Device Section Video Section PIP Device Selection Menu PIP/POP Selection Menu Menu Screens Overview Setup MenuAntenna Menu Clock Menu Captions Menu Timer MenuChip Lock Menu Audio/Video Menu Setup Menu Edit NetCommand Icon Position Edit NetCommand ButtonIcon Position Menu Setup Menu Convergence Reset Factory Defaults MenuConvergence Menu Advanced Convergence Menu Language MenuTransport Menu Channel MemoryName For ANT-A or ANT-B Using The Remote Control Antenna Menu SuperQuickView SQVSQV SuperQuickView Clock Setting Auto Clock Menu Auto or Manual Clock SettingClock Setting Manual Daylight Savings Time Captions Menu Analog and Digital Captions Captions Menu Digital Captions Settings Entry Chip Lock Menu PasscodePasscode Screen Chip Chip Lock Menu V-Chip Definitions Chip Signal Information Lock By Time Chip Menu Lock By Time and Front Button LockLock by Time, Lock Time, and Unlock Time Front Button Lock Timer On/Off Timer Menu Setting The TimerSet Time Device Audio/Video Settings Memory ResetUsing the Audio and Video Buttons on the Remote Control Video Mute TV Speakers Settings Menu TV Speakers Audio Settings Setting Descriptions Audio Video Settings Setting Descriptions Video Chapter Four Overview Remote Control Functions Overview Installing the Batteries Remote Control Functions Care and OperationFor Best Results from the Remote Control Operation Remote Control Functions Operation of PIP and POP Remote Control Functions Channel Selection and Sleep TimerChannel Selection Sleep Timer Activating the PIP and POP Changing PIP/POP Device Automatic POP SwitchingChanging PIP/Side-by-Side Channels Exchanging Program Images Definitions Remote Control FunctionsPage To Program the Remote to Control NetCommand A/V Products Programming the remote to control your satellite receiver DVD Remote Control Functions Special Functions Video game patterns and scoreboards Bypassing the V-Chip Lock Appendix a Bypassing the V-Chip LockBypassing Front Button Lock Appendix a Bypassing the V-Chip LockPage NetCommand Ieee 1394 & HAVi System Compatibility Input Levels and Timing When Used With RGB Video SignalsComponent-1 and Component-2 Inputs VGA Input Receivers Appendix C Remote Control Programming CodesDVD Players Satellite Receivers Cleaning Appendix D Cleaning and ServiceFor further assistance, call 800 Appendix D Cleaning and Service Appendix E Diamond Shield Instructions Installation Appendix F Cabinet Cabinet Separation for Model WS-65511 Appendix F Cabinet Separation Following operation should be performed by two people Cabinet Separation for Model WS-65712 Troubleshooting Problem Possible SolutionAppendix Appendix G Troubleshooting DisplayInformation ScreenOn HAppendix On Screen Information DisplaysAnalog Antenna or Devices Digital AntennaPage Index S-W Demo Mode Mitsubishi Projection Television Limited Warranty Mitsubishi Projection TV Limited Warranty Mitsubishi TV Software Page Page Connection Helpful Hints Mitsubishi Digital Electronics America, Inc 871D357B10