Setup Menu: Convergence
Convergence Menu
(Figure 1)
Your Mitsubishi TV has three picture tubes which need to be aligned to properly converge the projected light beams on the screen. Each picture tube projects a single color of red, blue or green. During production, your TV was carefully adjusted to properly align these colors. However, moving the TV, the TV’s location in relation to the Earth’s
magnetic poles, and the passage of time can cause Figure 1. Setup menu, (Convergence selected) these adjustments to change. As a special feature,
you have the ability to adjust the red and blue light beams in reference to the fixed green light beam. This process is called convergence. There are two separate memories for convergence. One, for SD 480i/480p signals; the other for HD 1080i signals.
SD convergence should be adjusted while watching an SD source; likewise, HD convergence should be adjusted while watching an HD source.
The TV should be fully warmed up before adjusting Convergence. Turn the TV On and wait at least 30 minutes before making adjustments.
Reset Factory Defaults Menu
(Figure 2)
This allows you to reset the convergence to |
|
the original factory settings. The message |
|
“Convergence reset completed” will be displayed |
|
when the factory defaults have been restored. | Figure 2. Reset Factory Defaults menu |
Convergence Menu
(Figure 3)
When the Red and Blue crosshairs are properly converged, the 
, 
, 
, or 
to move the Red and Blue crosshairs. Press VIDEO to switch between Red and Blue. Press AUDIO for the Advanced Convergence screen, and see Advanced Convergence, page 45, for instructions.
Red
Press ADJUST to converge the lines.
Press VIDEO to switch from Red to Blue.
Press MENU to go back.
Press CANCEL to delete changes.
Press AUDIO for Advanced Convergence.
Figure 2. Convergence screen
44
