Connecting an Analog VCR
Figure 1. Connecting VCR with antennas or wall outlet cable.
IMPORTANT
Additional connection cables are not provided with the TV. They are available at most electronic stores.
Figure 2. Connecting VCR with cable box.
Figure 3. Connecting the VCR Audio/Video.
VCR to Analog Antennas or Wall Outlet Cable (Figure 1)
1.Connect the incoming cable to
Note: Connect two coaxial cables as follows:
2.One from
3.One from VCR back panel ANTENNA OUT to
4.Now complete Figure 3, steps
VCR to Cable Box (Figure 2)
1.Connect the incoming cable to
Note: Connect three coaxial cables as follows:
2.One from
3.One from OUT on the back of the cable box to ANTENNA IN on the VCR back panel.
4.One from ANTENNA OUT on the VCR back panel to
5.Now complete Figure 3, steps
Adding Composite Video or an S-Video with Audio Connections
(Figure 3)
1.Connect a video cable from VIDEO OUT on the VCR back panel to VIDEO INPUT 1 on the TV back panel.
Note: If you have an
2.Connect a set of audio cables from AUDIO
OUT on the VCR back panel to AUDIO INPUT 1 on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel. If your VCR is mono
Note: Step 2 allows the use of the TV speakers with the VCR.
Important: If you add a second VCR or use any other inputs for your VCR, see the section on Editing NetCommand™ Setup to ensure this
change matches the NetCommand™ system.
19
