Figure 5. Programming the remote to control your A/V receiver.
IMPORTANT
If the remote control has not been programmed to operate NetCommand™ and slide switch is set to TV when you enter an A/V receiver code, VOLUME and MUTE will control the A/V receiver rather than the TV. To return volume and mute control to the TV, set the slide switch
to TV, press and hold POWER and enter 000.
VCR position:
VCR
DVD position:
DVD
Cable box
Audio position:
A/V receiver
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
Figure 4. Programming the remote to control your DVD/ LDP.
Programming the Remote Control to Control Non-NetCommand™
A/V ProductsAfter entering the correct codes in each position of the remote control, use the slide switch to select
which product will respond when an operational button is pressed. If the TV position has not been programmed to control NetCommand™ and you enter a code from the A/V Receiver chart while the slide switch is set to TV, the volume and mute functions change to match the A/V receiver. This is useful when using an A/V receiver with the TV all the time. In all other cases, only one of the below devices is allowed for each slide switch position.
TV position (when the remote has not been
programmed to operate NetCommand™):
TV
DVD
LD Player
LD Player
VCR
Cable box
Mitsubishi CD player [If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with selected Mitsubishi CD players. Your audio position must be programmed to 010 ].
IMPORTANT
Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, your remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.
68
