Mitsubishi Electronics WS-65711, WS-B55, ws-65712, WS-65511, WS-65611, WS-73711, WS-48511 Back Panel

Back Panel

�

Inputs 1-4

These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, DVD player, standard satellite receiver or other A/V device to the TV. Please note that if you connect to the S-VIDEO terminal, the VIDEO terminal is deactivated. The VIDEO terminal is active when there is no S-Video connection.

�

Output (Monitor and PIP)

The Monitor Output sends the TV audio and video signals from Ant-A, Ant-B and Inputs 1-5 to an A/V Receiver or other analog A/V equipment. Monitor Output will also provide the signals, converted to analog signals, received from Ant-DTV and IEEE-1394 products. There will be no video signals from digital products if the original signals are copy protected.

From VGA, Component 1 and 2 and Input-DTV, no signals will be sent. The PIP output sends the PIP’s or POP’s audio signal to an amplifier or wireless headphones. If no PIP or POP is displayed, the PIP output will not send any audio.

�

Antenna (ANT-A, LOOP OUT, and ANT-B)

ANT-A and ANT-B receive analog NTSC signals from VHF/UHF antennas or an analog NTSC cable system. LOOP OUT sends the ANT-A signal out to another component, such as a cable box or VCR.

4

IR Emitter-Repeater

Connecting IR emitters here allows the TV to pass IR commands from most IR remote controls to other A/V devices that are out of range of the remote control.

5

VGA

This input can be used for the connection of a computer. Please see Appendix B for signal compatibility.

6

Component Inputs 1-2

These inputs can be used for the connection of A/V equipment with component video outputs, such as a DVD player. Please see Appendix B for signal compatibility.

7

DTV Input

This input is used to connect an external DTV receiver, and can be configured for HDTV signal types component (YPrPb), RGB sync on green, and RGB plus H&V. Please see Appendix B for signal compatibility.

13