Axle Shaft, Roll PIN 3/16, Sprocket, Clik PIN

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PP265E27(96198002801)

DRIVE

					5
				6
			1b		4
			7		3
					3
		1b
		6		1a
			KEY	PART	DESCRIPTION
			NO.	NO.	DESCRIPTION
			1	188226	(assy of 1a,1b) AXLE ASSEMBLY
			1a	179352	AXLE SHAFT
		2	1b	9465M1	ROLL PIN 3/16
		2	2	402691	SPROCKET
		3	3	174697	THRUST WASHER
5	4	01.03.005-B	4	179830	BEARING
5	4		5	17490508	BOLT 5/16−18 X .500
			5	17490508	BOLT 5/16−18 X .500
			6	155443	CLIK PIN
			7	189282	SQUARE KEY

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.

Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 31

Image 31

Poulan 96198002801, 430429 owner manual Axle Shaft, Roll PIN 3/16, Sprocket, Clik PIN

Contents

Snow Thrower Model Number Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Parts Packed Separately in Carton Install Traction Drive Control ROD See Figs Install Speed Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotator Head See Fig Install Auger Control ROD See Figs Check Tire Pressure Install Chute Deflector Remote Control See Figs Ignition KEY OperationKnow Your Snow Thrower Primer Recoil auxiliary starter handle used for starting engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow Thrower To Throw Snow See Fig Using the CLEAN-OUT Tool See FigTo Move Forward and Backward See Fig To Start Engine Before Starting the Engine Before Stopping Snow Throwing TipsIf Recoil Starter has Frozen Maintenance Engine Cleaning Shear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute Deflector To Replace Belts See Fig Engine Speed To Adjust Cable Tension See FigTo Remove Wheels See Fig Carburetor Engine OIL StorageOther Fuel System Troubleshooting Auger 27 LH Auger HousingKEY Part Description Scraper BAR 23 22 KEY Part NO. NO. Description Bearing Plug Auger Bearing Deflector Weldment Deflector Control AssemblyDeflector Spring 15 420679 Service Part Deflector Control Chute Weldment Rotator Head LEVER/CABLE Rotator AssemblyCable Assembly Adjustable Cable Assembly Heat Shield Pivot Support Loop Handle LHLoop Handle RH Lower Tube Handle Knob SpacerRetainer Knob RED Shifter ROD Bottom Impeller ROD AssemblyTraction ROD Assembly Shifter ROD TOP Interlock Stop Interlock SpringInterlock CAM Torsion Spring Clik PIN Axle ShaftRoll PIN 3/16 Sprocket Exploded Rubber Ring AssemblyDrive Plate Assembly Speed Selector 428685 Frame427928X428 Engine Mounting Plate Idler Pulley Impeller BeltTraction Belt Idler ARM Bracket 187833X421 Wheel Assembly LH187865X421 428498 Safety Ignition KEYKEY Part NO. no DECAL, Danger 181037DECAL, DANGER, Deflector KEY Part Description QTY MANUFACTURER’S Warranty Coverage Warranty II. Emission Control System Warranty Warranty Limited Warranty

KEY

AXLE SHAFT

ROLL PIN 3/16

SPROCKET

CLIK PIN