OPERATION
GASOLINE
FILLER 
CAP
PRIMER
CHOKE
CON-
TROL
SAFETY
IGNITION KEY
FUEL
THROTTLE
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
AUGERS
POWER |
|
|
| |
CORD | AUGER | DISCHARGE CHUTE CONTROL LEVER | ||
PLUG | ||||
CONTROL | ||||
| LEVER |
| DEFLECTOR REMOTE | |
| DRIVE SPEED | |||
| CONTROL LEVER | |||
ELECTRIC | CONTROL LEVER | |||
| ||||
|
|
| ||
START |
|
|
| |
BUTTON |
|
| TRACTION | |
| CHUTE |
| ||
|
| DRIVE | ||
DEFLECTOR |
| |||
| CONTROL | |||
|
|
| ||
|
|
| LEVER | |
DISCHARGE | LIGHT | |
CHUTE | ||
|
HANDLE | |
| KNOB |
| MUFFLER |
| TOOLBOX |
SKID PLATE
FIG. 10
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Throttle- used to select FAST or SLOW engine speeds. Choke Control - used for starting a cold engine.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the direc- tion the snow is thrown.
Deflector remote control lever - used to change the distance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
9
