193071, Safety Ignition KEY | Poulan 437126, 96198003303 manual

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PP1150E27 (96198003303)

BAG OF PARTS

01.14.003-B

5	6	KEY	PART
		KEY	PART
	8	NO.	NO.	DESCRIPTION
		NO.	NO.	DESCRIPTION
7		1	198563	POWER CORD
7		1	198563	POWER CORD
		2	169675	RETAINER PIN
		3	180684	WRENCH
		4	184505	REMOTE SPRING
	9 10	5	179829	SHOULDER BOLT 1/4-20
	9 10	6	191730	LOCKNUT 1/4-20
		7	72250505	CARRIAGE BOLT 5/16-18 X 5/8
		8	751153	LOCKNUT 5/16-18
		9	73800600	LOCKNUT 3/8-16
		10	19131316	WASHER 3/8
		11	192090	SHEAR BOLT 1/4-20 X 1-13/16
1	12	12	73800400	LOCKNUT 1/4-20
1	12
	11

	KEY	PART	DESCRIPTION
1	NO.	NO.	DESCRIPTION
1	1	193071	SAFETY IGNITION KEY

01.14.007-A

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 40

Page 40

Image 40

Poulan 437126, 96198003303 owner manual 193071, Safety Ignition KEY

Contents

Model Number Snow Thrower Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Assembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerParts Packed Separately in Carton Remove Snow Thrower from Carton Install Traction Drive Control ROD See Figs Install Speed Control ROD See FigsUnfold Upper Handle Install Auger Control ROD See Figs Install Discharge Chute / Chute Rotater Head See Fig Install Chute Deflector Remote Control See Figs Check Tire Pressure Operation Know Your Snow ThrowerPrimer Ignition KEY Meets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engine HOW to USE Your Snow Thrower StoppingTo USE Choke Control See Fig To Control Snow Discharge See Fig Using the CLEAN-OUT Tool See Fig Power Steering Operation See FigTo Throw Snow See Fig To Move Forward and Backward See Fig To Adjust Skid Plates See Fig Before Starting the EngineScraper BAR See Fig Check Engine OIL Level See Fig Snow Throwing Tips To Start EngineBefore Stopping If Recoil Starter has Frozen Maintenance General RecommendationsBefore Each USE Lubrication Cleaning Engine Service and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See Fig To Replace Belts See Fig To Adjust Cable Tension See Fig To Remove Wheels See FigCarburetor Engine Speed Storage OtherFuel System Engine OIL Troubleshooting Service Notes Exploded KEY Part Description Auger Housing Scraper BARAuger Bearing Bearing Plug Auger 27 LH Auger 27 RHSkid Plate LH Skid Plate RH Deflector Seal Knob BlackPOP Rivet Chute Snow Shield 419822X431 Shield Retainer Strap LEVER/CABLE Rotator Assembly Cable Assembly AdjustableCable Assembly Heat Shield Rotator Head Loop Handle LH Loop Handle RHLower Handle Pivot Support Weldment Spacer RetainerKnob RED Handle Knob Carriage Bolt 5/16-18 X 155377 NUT 5/16-18 169675 Wire Harness Console PanelHeadlight Bezel Flood Headlight Repair Parts Snow Thrower - Model Number PP1150E27 Drive Speed Selector Assembly Drive Plate AssemblyWheel HUB END Plate Axle Shaft Sprocket ENGINE, B&S Frame436146X428 Engine Mount Plate Impeller Belt Traction BeltIdler ARM Bracket Idler Pulley 428684 Cable Bracket LH Wheel Assembly LHCable Bracket RH Cover Wheel Driver Retainer RingWheel Lobe Clutch Slide Safety Ignition KEY 193071 01.14.012-A Shifter ROD TOP Shifter ROD Bottom 181037 DECAL, DangerDECAL, DANGER, Deflector DECAL, Instruction Service Notes Limited Warranty

01.14.003-B

KEY

SHOULDER BOLT 1/4-20

WASHER 3/8

KEY

193071

SAFETY IGNITION KEY

01.14.007-A