Rib
Groove
DInsert the elbow tube into the blower outlet. Make sure elbow tube rib is aligned with the
blower outlet groove.
DTurn clamp knob clockwise to tighten.
D Secure the ends of the shoulder strap by routing the strap through the buckle as shown.
VACUUM TUBE ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury.
D Align the lower vacuum tube as shown. Push lower vacuum tube into upper vacu- um tube.
Upper Vacuum
Tube
Lower Vacuum Tube
DInsert a screwdriver into the latch area on the vacuum inlet cover.
|
|
|
|
|
|
|
|
|
|
|
|
|
| Blower | |
Latch |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| Outlet | |||||
Area |
|
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Latch Area | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Vacuum | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Inlet Cover | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
| |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DGently tilt the handle of the screwdriver to- ward the back of the unit while pulling up on the vacuum inlet cover with your other
hand.
DHold the vacuum inlet cover open until up- per vacuum tube is installed.
Vacuum Inlet
Retaining Post
Vacuum
Inlet
Cover
DPlace the hooks on the vacuum tube on the retaining posts; pivot tube into position. Se- cure vacuum tube by turning the knob clockwise until tight.
Knob 
Hooks
D When converting back to the blower fea- ture, make sure latch on the vacuum inlet cover is securely fastened.
WARNING: You MUST make sure the tubes are secure before using the unit.
OPERATING POSITION
Eye 
Protection
BlowerVacuum
OPERATING TIPS
S While vacuuming or blowing debris, hold the unit with the muffler side facing away from your body and clothes (see illustration above).
S To reduce the risk of hearing loss associated with sound level(s), hearing protection is required.
STo reduce the risk of injury associated with contacting rotating parts, stop the engine be- fore installing or removing attachments. Do
not operate without guard(s) in place.
SOperate power equipment only at reasonable
