1st Cut
2nd Cut
Using a support stand
2nd Cut
1st Cut
1st Cut
2nd Cut
LIMBING AND PRUNING
WARNING: Be alert for and guard against kickback. Do not allow the moving chain to contact any other branches or ob- jects at the nose of the guide bar when limb- ing or pruning. Allowing such contact can re- sult in serious injury.
WARNING: Never climb into a tree to limb or prune. Do not stand on ladders, platforms, a log, or in any position which can cause you to lose your balance or control of the saw.
IMPORTANT POINTS
S Work slowly, keeping both hands firmly gripped on the saw. Maintain secure foot- ing and balance.
S Watch out for springpoles. Springpoles are small size limbs which can catch the saw chain and whip toward you or pull you off balance. Use extreme caution when cutting small size limbs.
S Be alert for springback. Watch out for branches that are bent or under pressure. Avoid being struck by the branch or the saw when the tension in the wood fibers is released.
SKeep a clear work area. Frequently clear branches out of the way to avoid tripping over them.
LIMBING
SAlways limb a tree after it is cut down. Only then can limbing be done safely and prop-
erly.
S Leave the larger limbs underneath the felled tree to support the tree as you work.
SStart at the base of the felled tree and work toward the top, cutting branches and
limbs. Remove small limbs with one cut.
SKeep the tree between you and the chain. Cut from the side of the tree opposite the branch you are cutting.
SRemove larger, supporting branches with
the cutting techniques described in BUCK-
ING WITHOUT A SUPPORT.
S Always use an overcut to cut small and freely hanging limbs. Undercutting could cause limbs to fall and pinch the saw.
PRUNING
WARNING: Limit pruning to limbs shoulder height or below. Do not cut if branches are higher than your shoulder. Get a professional to do the job.
SMake your fist cut 1/3 of the way through the bottom of the limb.
SNext make a 2nd cut all the way through the limb. Then cut a third overcut leaving a 1 to 2 inch collar from the truck of the tree.
Second cut
Third cut
Collar
First cut
Pruning technique
WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments.
We recommend all service and adjustments not listed in this manual be performed by an authorized service dealer.
13
