Poulan 952044370 Maintenance, Limbing, Pruning, through the limb, Customer Responsibilities

LIMBING

SLimb a tree only after it is cut down. S Leave the larger limbs underneath the

felled tree to support the tree as you work.

S Start at the base of the felled tree and work toward the top, cutting branches and limbs. Remove small limbs with one cut.

S Keep tree between you and the chain. S Remove larger branches with the cut- ting techniques described BUCKING

WITHOUT A SUPPORT.

S Always use an overcut to cut small and freely hanging limbs. Undercut- ting could cause limbs to fall and pinch the saw.

PRUNING

WARNING: Limit pruning to limbs shoulder height or below. Do not cut if branches are higher than your shoulder. Get a professional to do the job.

S Make your first cut 1/3 of the way through the bottom of the limb. This cut will make the limb sag so that it falls easily on the second cut.

S Next make a second cut all the way

through the limb.

SFinish the pruning operation by using an overcut so that the stump of the limb protrudes 1 to 2 inches (3--5 cm) from the trunk of the tree.

Second cut

First cut 1/3 of way

3rd cut 1 to 2 in. (3--5 cm) from trunk of tree

MAINTENANCE

CUSTOMER RESPONSIBILITIES

WARNING: Disconnect power source before performing maintenance.

Fill in dates as you complete	Before	After	Every	Service
regular service	Use	Use	15 min.	Dates
Check for damaged/worn parts	n
Check for loose fasteners/parts	n
Check chain tension	n
Check chain sharpness	n
Check guide bar	n
Check bar and chain oil level	n		n
Inspect and clean unit & labels		n
Clean guide bar groove		n

GENERAL RECOMMENDATIONS

The warranty on this unit does not cover items that have been subjected to oper- ator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjustments will need to be made periodically to properly maintain your unit. Improper mainte- nance may cause damage to the unit and possible injury to the operator or by- standers.

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for replacement of worn or damaged parts.

11

NOTE: It is normal for a small amount of oil to appear under the saw after motor stops. Do not confuse this with a leaking oil tank.

S Trigger Switch -- Ensure the trigger switch functions properly by squeez- ing and holding the trigger switch. Make sure motor starts and stops.

S Oil Tank -- Discontinue use of chain saw if oil tank shows signs of damage or leaks.

S Extension Cord -- Discontinue use if chain saw extension cord shows signs of damage or wear.