Xerox 6250 manual Laser Safety, Maintenance Safety, Operational Safety

Do not remove the covers or guards that are fastened with screws unless you are installing optional equipment and are specifically instructed to do so. Power should be OFF when performing these installations. Except for user-installable options, there are no parts that you can maintain or service behind these covers.

Note

Leave the printer on for optimum performance; it does not pose a safety hazard.

The following are hazards to your safety:

■The power cord is damaged or frayed.

■Liquid is spilled into the printer.

■The printer is exposed to water.

If any of these conditions occur:

1.Turn off the printer immediately.

2.Disconnect the power cord from the electrical outlet.

3.Call an authorized service representative.

Laser Safety

With specific regard to lasers, this printer complies with laser product performance standards set by governmental, national, and international agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardous light because the beam is totally enclosed during all modes of customer operation and maintenance.

Maintenance Safety

■Do not attempt any maintenance procedure that is not specifically described in the documentation supplied with your printer.

■Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance and could create a hazardous condition.

■Do not burn any of the supplies (such as a toner cartridge, fuser, or transfer roller). For information on Xerox supplies recycling programs, go to www.xerox.com/officeprinting/ recycle.

Operational Safety

Your printer and supplies were designed and tested to meet strict safety requirements. These include safety agency examination, approval, and compliance with established environmental standards.

Your attention to the following safety guidelines helps to ensure the continued, safe operation of your printer.

Phaser® 6250 Color Laser Printer

A-2