GUIDE BAR AND CHAIN OIL
The bar and chain require lubrication. The chain oiler provides lubrication to the chain and guide bar. Be sure to fill the bar oil tank before each cutting session. Lack of oil will quickly ruin the bar and chain. Too little oil will cause overheating shown by smoke coming from the chain and/or discoloration of the bar. For maximum guide bar and chain life, we recommend you use Poulan chain saw bar oil. If Poulan bar oil is not available, you may use a good grade SAE 30 oil until you are able to obtain Poulan brand. Use a funnel to fill the tank. Replace oil cap securely. Check oil level after every 15 minutes of operation.
STOPPING YOUR SAW
SRelease the trigger switch.
SIf motor does not stop, disconnect the extension cord. Discontinue use of the unit until it has been repaired by an authorized service dealer.
STARTING YOUR SAW
1.Connect the saw to a power source using the proper size extension cord; see SELECT AN EXTENSION CORD).
2.Grip both handles firmly.
3.Push and hold the trigger
4.Squeeze and hold the trigger switch.
CUTTING METHODS
OPERATING TIPS
SCheck chain tension before first use and after 1 minute of operation. See
CHECK CHAIN TENSION in the MAIN-
TENANCE section.
SCut wood only. Do not cut metal, plas- tics, masonry,
terials, etc.
SStop the saw if the chain strikes a for-
eign object. Inspect the saw and repair parts as necessary.
S Keep the chain out of dirt and sand. Even a small amount of dirt will quickly dull a chain and increase the possibil- ity of kickback.
S Practice cutting a few small logs using the following steps. This will help you get the “feel” of using your saw before you begin a major sawing operation.
SSqueeze trigger switch and allow unit to reach full speed before cutting.
S Begin cutting with the saw frame against the log.
SKeep the motor at full speed the en- tire time you are cutting.
S Release the trigger switch as soon as the cut is completed, allowing the motor to stop.
SKeep the cord away from the cutting area. Position cord so it will not be caught on branches and the like dur- ing cutting.
S To avoid losing control when cut is complete, do not put pressure on saw at end of cut.
SStop motor before setting saw down.
TREE FELLING TECHNIQUES
WARNING: Check for broken or dead branches which can fall while cut- ting causing serious injury. Do not cut near buildings or electrical wires if you do not know the direction of tree fall, nor cut at night since you will not be able to see well, nor during bad weather such as rain, snow, or strong winds, etc. If the tree does make contact with any utility line, the utility company should be noti- fied immediately.
SCarefully plan your sawing operation in advance.
S Clear the work area. You need a clear area all around the tree so you can have secure footing.
S The chain saw operator should keep on the uphill side of the terrain as the tree is likely to roll or slide downhill af- ter it is felled.
S Study the natural conditions that can cause the tree to fall in a particular direc- tion, such as:
SThe wind direction and speed.
S The lean of the tree. The lean of a tree might not be apparent due to un- even or sloping terrain. Use a plumb or level to determine the direction of tree lean.
SWeight and branches on one side. S Surrounding trees and obstacles.
SLook for decay and rot. If the trunk is rotted, it can snap and fall toward the
operator.
S Make sure there is enough room for the tree to fall. Maintain a distance of
8
