Bosch Appliances UML-102-90, UML-100-90 Connecting the Composite Video Signal to the Monitor

24 en Installing the Monitor Small Size LCD/LED Monitors

5.2.2Wall Mount Installation

This monitor can be wall-mounted using the square mounting holes (75 mm [2.95 in.] centers) and a suitable wall mount or swivel/tilt mount.

Figure 5.2 Location of mounting holes

5.3Connecting the Composite Video Signal to the Monitor

There are two (2) BNC connectors located on the rear side panel of the monitor for composite video inputs and two (2) BNC connectors for composite video outputs (see Figure 3.2 and Figure 3.3).

Note: All video inputs are passive loop-through. The impedance is automatically set to 75 Ohm by the input of the signal on the input connector, while operating in a single connection mode (see Figure 5.5). If a cable is also connected to the output connector, the video signal can be passed on to another monitor connected to it via the passive loop-through function.

F.01U.134.499 1.0 2009.07 User Manual Bosch Security Systems, Inc.