TRIMMER HEAD | DEPTH ADJUSTMENT KNOB | |
The TRIMMER HEAD holds the cutting line | The DEPTH ADJUSTMENT KNOB is used | |
and rotates during operation. It is designed to | to adjust the wheel for blade cutting depth | |
cut grass. | when edging. | |
BLADE |
|
|
The BLADE is designed to cut sod. |
|
|
|
|
|
BEFORE STARTING ENGINE |
|
|
WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. Call
FUELING ENGINE
WARNING: Remove fuel cap slowly when refueling.
HELPFUL TIP
To obtain the correct oil mix ratio, pour 3.2 ounces of
ON/STOP
Switch
HOW TO START YOUR UNIT
WARNING: Avoid any contact with the muffler. A hot muffler can cause serious burns.
Starting position
This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic
to fuel before fueling your unit.
CAUTION: Never use straight gasoline in your unit. This will cause permanent engine damage and void the limited warranty.
FUEL REQUIREMENTS
This engine requires the use of minimum 87 octane [R+M]/2 clean gasoline.
IMPORTANT
Use of alcohol blended fuels (called gasohol or using ethanol or methanol) can cause major en- gine performance and durability problems.
WARNING: Alternative fuels (not gas- oline) such as
HOW TO STOP YOUR UNIT
SRelease the throttle trigger.
S Push and release the engine ON/STOP switch. The switch will automatically return to the ON position. Wait 5 seconds before at- tempting to restart unit to allow switch to reset.
HELPFUL TIP
If your engine still does not start after following these instructions, please call
STARTING A COLD ENGINE
NOTE: DO NOT squeeze the throttle trigger until the engine has started and runs.
1.Set unit on a flat surface.
2.Slowly press the primer bulb 6 times.
3.Move the start lever to the START posi- tion.
Primer Bulb
Start Lever
Starter Handle
11