OPERATION
SPARK | ENGINE OIL CAP | AUGER |
PLUG | WITH DIPSTICK | CONTROL |
SAFETY |
| LEVER |
IGNITION |
|
KEY | GASOLINE |
| |
| FILLER |
| CAP |
CHOKE | CHUTE | |
DEFLECTOR | ||
CON- | ||
| ||
TROL |
|
OIL
DRAIN
PLUG
THROTTLE
/ ENGINE
CONTROL
DISCHARGE
CHUTE
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED | DEFLECTOR REMOTE | |
CONTROL LEVER | ||
CONTROL LEVER | ||
|
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
RECOIL | POWER |
|
|
(AUXILIARY) |
|
| |
CORD |
|
| |
STARTER |
|
| |
PLUG | ELECTRIC |
| |
HANDLE |
| ||
|
| ||
|
| START | FUEL |
|
| BUTTON | |
PRIMER |
|
| VALVE |
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
CLEAN-
OUT
TOOL
FIG. 10
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
FREEWHEEL CONTROL
DRIFT CUTTER
SKID PLATE
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Drift cutter - used to cut through deep snowdrifts.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Freewheel control – disengages transmission for pushing the snowthrower with the engine off.
Choke control - used for starting a cold engine.
LH and RH turn triggers - used to steer the snow thrower.
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
Deflector remote control lever - used to change the
9 distance the snow is thrown.
