OPERATION
GASOLINE
FILLER CAP
MUFFLER
CHOKE
CON-
TROL
PRIMER
SAFETY
IGNITION
KEYFUEL
VALVE ON / OFF SWITCH
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ELECTRIC AUGER
START BUTTON CONTROL LEVER
RECOIL (AUXILIARY)
STARTER
HANDLE
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
CLEAN-
OUT
TOOL
FIG. 8
DRIVE DISCHARGE TRACTION
SPEEDCHUTEDRIVE
CONTROL CONTROL CONTROL
LEVERLEVER LEVER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine. | 8 |
|
ON / OFF switch - used to STOP the engine.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.