OPERATION

•Avoid stopping or changing speed on hills.

•If slowing is necessary, move throttle control lever to slower position.

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move motion control lever to neutral (N) position.

IMPORTANT: THE MOTION CONTROL LEVER DOES NOT RETURN TO NEUTRAL (N) POSITION WHEN THE CLUTCH/ BRAKE PEDAL IS DEPRESSED.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Slowly move motion control lever to slowest setting.

•Make all turns slowly.

TO TRANSPORT (See Figs. 7 and 11)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with attachment lift control.

•Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

Transmission Engaged

Transmission Disengaged

FIG. 11

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 7)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

14

Page 13 Page 15
Page 14
Image 14
Poulan DB24H48YT manual Before Starting the Engine, To Transport See Figs, Check Engine OIL Level, ADD Gasoline
Page 13 Page 15

DB24H48YT specifications

The Poulan DB24H48YT is a versatile and robust lawn tractor designed to meet the diverse needs of homeowners managing their lawns and gardens. This model stands out for its powerful performance and various features that make yard work less tedious and more efficient.

One of the key characteristics of the Poulan DB24H48YT is its potent 24-horsepower Briggs & Stratton engine. This reliable engine delivers plenty of power for tackling both flat and uneven terrains, ensuring that cutting through thick grass is no challenge. The engine is paired with a hydrostatic transmission, providing smooth and effortless operation, with the ability to change speed seamlessly during mowing tasks without the need for manual gear shifting.

Featuring a 48-inch cutting deck, the Poulan DB24H48YT offers a wider cutting path, reducing the number of passes needed to achieve a well-manicured lawn. The cutting height is adjustable, allowing users to choose optimal grass height according to their preferences or seasonal requirements. With its three-blade system, this lawn tractor delivers an even and precise cut, enhancing the overall aesthetic of lawns.

Another noteworthy feature of the Poulan DB24H48YT is the inclusion of an ergonomic control system, designed for user comfort. The soft-touch steering wheel provides excellent grip, while the adjustable seat ensures that operators can find their most comfortable position during lengthy mowing sessions. Easy access to the key controls facilitates quick adjustments while maneuvering around obstacles in the yard.

Equipped with exceptional maneuverability thanks to the tight turning radius, this model can navigate around flower beds, trees, and other landscaping features with ease. The Poulan DB24H48YT also supports various attachments, expanding its functionality for tasks beyond mowing, such as mulching, hauling, or snow removal.

Overall, the Poulan DB24H48YT embodies a well-rounded combination of power, durability, and versatility, making it an excellent choice for homeowners seeking an efficient solution for lawn care. Its blend of advanced features and technological innovations ensures that it provides reliable performance year after year, helping users maintain pristine lawns with ease.
Top Page Image Contents