Coupler Primary Hole
Guide Recess
Upper Locking/ Lower
Shaft Release Attachment
Button
WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless otherwise
ATTACHING THE SHIELD
WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you.
For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OPERATION section.
1.Remove wing nut from shield.
2.Insert bracket into slot as shown.
3.Pivot shield until bolt passes through hole in bracket.
4.Securely tighten wing nut onto bolt.
stated in the applicable attachment instruction manual. Using the wrong hole could lead to seri- ous injury or damage to the unit.
Secondary Hole
Bracket
Slot
Wing Nut
Shield
Gearbox
Locking/Release
Button in Primary Hole
For optional attachments, see the ASSEMBLY section of the applicable attachment instruction manual.
ADJUSTING THE HANDLE
WARNING: When adjusting the han- dle, be sure it remains above the safety label and below the mark or arrow on the shaft.
1.Loosen wing nut on handle.
2.Rotate the handle on the shaft to an up- right position; retighten wing nut.
OPERATION
KNOW YOUR UNIT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Muffler
| Assist Handle | |
| Coupler |
|
Trimmer | Shaft |
|
Head | Spark | Throttle Trigger |
| ||
| Plug |
|
| Shield | Primer Bulb |
|
| |
Line Limiter |
| Start |
| Lever | |
Blade |
| |
ON/OFF Switch |
| |
|
| |
|
| Starter handle |
7