Reduced Kickback Symmetrical Guide Bar
Small Radius Tip
Symmetrical Guide Bar
Large Radius Tip
S
Contoured Depth Gauge
| Elongated Guard Link | |
| Deflects | |
kickback force | ||
and allows wood | ||
Chain | ||
to gradually ride | ||
| into cutter | |
| Can Obstruct Material |
Not a
TRANSPORTING AND STORAGE
SDo not grasp or hold exposed blade. S Stop unit before leaving work area.
SAllow unit and gearbox to cool before storing
or transporting it in a vehicle.
SStore unit and fuel in area where fuel vapors cannot reach sparks or open flames from wa- ter heaters, electric motors or switches, fur-
naces, etc.
SStore attachment so blade cannot accidental-
ly cause injury.
SStore attachment indoors, out of reach of chil- dren.
If situations occur which are not covered in this manual, use care and good judgment. If you need assistance, call
SPECIAL NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnor- mal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An
SAVE THESE INSTRUCTIONS
ASSEMBLY
WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find parts missing or damaged, call
TOOLS REQUIRED
SHex wrench (provided)
INSTALLING PRUNER ATTACH- MENT
CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.
NOTE: The pruner attachment connects to the engine end shaft through use of a coupler system. For extra reach, the extension shaft (included) can be used.
1.Loosen the couplers on the extension shaft and on the engine end shaft by turn- ing the knobs counterclockwise.
Coupler
AttachmentLOOSEN
Knob
TIGHTEN
2.Remove the shaft cap from the pruner attachment (if present).
3.Position locking/release button of attach- ment into guide recess of coupler on extension shaft.
4.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
Coupler Primary Hole
Guide Recess
Locking/
Upper Release Attachment
Shaft Button
5.Repeat steps to attach extension shaft to coupler on engine end shaft.
6