OPERATION
KNOW YOUR PRUNER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR PRUNER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Pruner
Shaft
Extension Shaft
PRUNER
The PRUNER is designed for removal of limbs and branches overhead not greater than 6 inches (15 cm) in diameter.
Hanger
Bar Oil Fill Cap
Chain
Bar | Bar Nut |
|
CHAIN TENSION
It is normal for a new chain to stretch during first 15 minutes of operation. You should check your chain tension frequently. See CHAIN TENSION in the SERVICE AND AD- JUSTMENTS section.
OPERATING THE COUPLER
Your unit is equipped with a coupler system which enables optional attachments to be installed. The optional attachments are:
MODEL:
Edger . . . . . . . . . . . . . . . . . . . . . PPB1000E Cultivator . . . . . . . . . . . . . . . . . . PPB2000T Blower . . . . . . . . . . . . . . . . . . . . PPB3000B Pruner . . . . . . . . . . . . . . . . . . . . PPB5000P Brushcutter* . . . . . . . . . . . . . . . PPB4000C *not designed for use with
WARNING: Always stop unit and dis- connect spark plug wire (or disconnect unit from power source) before removing or instal- ling attachments.
REMOVING PRUNER ATTACHMENT (OR OTHER OPTIONAL ATTACH- MENTS)
CAUTION: When removing or installing at- tachments, place the unit and attachment on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Coupler
AttachmentLOOSEN
Knob
TIGHTEN
2. Press and hold the locking/release button.
Locking/Release
Button
Attachment | Coupler | Upper Shaft |
3.While securely holding the engine end shaft and extension shaft, pull the attachment straight out of the extension shaft coupler.
4.Repeat steps to remove extension shaft from coupler on engine end shaft.
INSTALLING OPTIONAL ATTACH- MENTS
CAUTION: DO NOT use extension shaft
with other optional attachments.
1.Remove the shaft cap from the attachment (if present) and discard.
2.Position locking/release button of attach- ment into guide recess of coupler on engine end shaft.
3.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the knob se- curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Locking/
Upper Release Attachment
Shaft Button
8