6.Before using the unit, tighten both knobs securely by turning clockwise.
WARNING: Make sure the locking/ release button is locked in the primary hole of both couplers and the knobs are securely tightened before operating the unit. Using the wrong holes could lead to serious injury or dam- age to the unit.
Locking/Release
Button in Primary Hole
SHOULDER STRAP ASSEMBLY
WARNING: Proper shoulder strap and handle adjustments are required before use. The shoulder strap clamp must be installed as shown above the assist handle on the engine end shaft.
NOTE: The lower shoulder strap clamp has two spacer tabs attached. These tabs are provided to adapt this attachment for use with units that have a 1 inch (2,5 cm) diameter shaft (the shoulder strap clamp will not tighten down securely on the 1 inch (2,5 cm) diameter shaft without using these spacer tabs). The tabs must be broken off completely before use and placed over the screw holes on the lower shoulder strap clamp. These tabs are not needed for units with a 7/8″ (2,2 cm) shaft.
LOWER SHOULDER STRAP CLAMP
Spacer Tabs
Spacer Tabs positioned for use on 1 inch (2,5 cm) diameter shaft
1.Place the upper shoulder strap clamp over the shaft above the assist handle.
2.Position the lower shoulder strap clamp under the upper shaft and align the upper and lower clamp screw holes (use spacer tabs between upper and lower clamps if necessary to secure clamp, i.e. for 1 inch (2,5 cm) diameter shaft).
Upper Shoulder
Strap Clamp
ENGINE/MOTOR
END
Lower Shoulder | ATTACHMENT | |
END | ||
Strap Clamp | ||
Screws | ||
|
3.Insert two screws into the screw holes.
4.Secure shoulder strap clamp by tighten- ing screws with the hex wrench.
5.Try on shoulder strap and adjust for fit and balance before starting the engine or begin- ning a cutting operation.
6.Insert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign
is on your back and the hook is to the right side of your waist.
NOTE: A
7.Adjust the strap, allowing the hook to be about 3
8.Fasten the strap hook to the upper clamp and lift the tool to the operating position.
Shoulder Strap
Shoulder
Strap
Clamp
ADJUSTING THE ASSIST HANDLE
WARNING: When adjusting the as- sist handle, be sure it remains directly above the coupler on the engine end shaft to ensure proper balancing of unit.
Assist Handle
Coupler
7