Power Acoustik owner manual Wiring Connections, Variable LOW-PASS FILTER40Hz-250Hz

WIRING CONNECTIONS

A.CONNECTING THE POWER

CAUTION:

AS A PRECAUTION,IT IS ADVISABLE TO DISCONNECT THE VEHICLES BATTERY BEFORE MAKING CONNECTION TO THE +12 VOLTS SUPPLY WIRING.

4/8 GAUGE(Or thicker if planning for additional Amplifiers)wire is recommended for both the power and ground wires.12 Gauge,for the remote turn wire.Both types are

available at most Mobile Audio Dealers or Installation Shops.

(1)GROUND:To Vehicle Chassis

To avoid unwanted ignition noise caused by ground loops,it is essential that the Amplifier be grounded to a clean,bare,metal surface of the vehicles chassis. NOTE:

GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT.(1 METER).

(2)+12Volt(Fused) Constant Power:To Battery(+)

Due to the power requirements of the Amplifier,this connection should be made directly to the positive (+) terminal of battery.For safety measure,install an in-line Fuse Holder (not included) as close to the battery positive (+) terminal as possible with an ampere rating:not to exceed total value of fuses in Amp.

OV2-420:20A/OV2-600:30A/OV2-800:20AX2/OV2-1250:25AX2/OV2-1800:30AX2 OV2-2200:25AX3/OV2-2600:30AX3/OV4-840:20AX2/OV4-1200:25AX2/OV4-1600:40AX2

(3)Remote Turn-On Input:To Power Antenna output of Car Stereo

This Amplifier is turned ONremotely when the vehicles stereo is turned ON .

NOTE:

IF YOUR SOURCE UNIT DOES NOT HAVE AN ACTIVE +12 VOLT LEAD WHEN IT IS TURNED-ON,YOU CAN EITHER INSTALL AN AUXILIARY SWITCH,OR YOU CAN TAP-INTO AN IGNITION LEAD;NOTE HOWEVER,THAT YOUR AMPLIFIER WOULD TURN-ON,EVERY TIME YOU START YOUR CAR IF YOU CHOSE THE IGNITION OPTION.

OV2-420/OV2-600/OV2-800/OV2-1250/OV2-1800

OV2-2200/OV2-2600/OV4-840/OV4-1200/OV4-1600

12V REM GND

POWER INPUT

Fuse

	Near Battery
BATTERY	Remote Turn-ON is
	connected to Radio s power	Vehicle chassis ground
	antenna lead or a switchable +12V

5

B.VARIABLE LOW-PASS FILTER(40Hz-250Hz)

For use as a dedicated subwoofer channel,set filter switch toLPF .Adjust variable crossover frequency with control as desired.The amplifier input circuit filters out everything above 40....250Hz(depends on the adjustment of the frequency control),

so only the deepest bass notes are amplified. C.VARIABLE HIGH-PASS FILTER(40Hz-250Hz)

For use as a dedicated high ranged channel,set filter switch to HPF .The input circuit filters out all frequencies below 40Hz....250Hz.

D.BASS BOOST

By using the bass boost function the deepest bass notes at 50Hz are emphasized.

BASS BOOST

OV2-1250/OV2-1800/OV2-2200/OV2-2600

E.CONNECTING HIGH LEVEL INPUTS

NOTE:

DO NOT CONNECT THESE HIGH LEVEL INPUT WIRES IF YOU ARE USING THE LOW LEVEL INPUT RCA JACKS.

CAUTION

NOTE THAT ONLY POSITIVE(+)WIRES ARE USED.DO NOT CONNECT SPEAKER NEGATIVES.

OV2-420/OV2-600

CHASSIS GROUND-Black

CH1(-) CH2(-)

CH1(+) CH2(+)

6