![](/images/new-backgrounds/1102528/10252819x1.webp)
Operation
• Save all instructions
A | Before Starting the Engine (Continued) |
5.Engine oil is at proper level.
6.Fresh, clean,
7.Spark plug wire is connected to spark plug.
8.Edger has been moved to desired location.
9.Edger is on level surface.
WARNING
Keep all bystanders, especially CHILDREN, away during operation.
IMPORTANT: This unit’s engine exhaust system is equipped with a
B How to Start Engine
DANGER
Never Run engine indoors or in a poorly ventilated area. Engine exhaust contains Carbon Monoxide, an ODORLESS and DEADLY gas.
WARNING
Debris thrown from edger can cause severe eye damage. Always wear ANSI compliant safety glasses or eye shields when operating edger. If you wear eyeglasses, put an OSHA certified Wide Vision Safety Mask over your eyeglasses.
1. Review ALL steps in the “BEFORE STARTING THE ENGINE” section.
2. Move the Depth Control Lever to the Start Position. (See Figure 6)
3. Rotate Choke to the Choke Position. (See Figure 5) NOTE: Not required when
4. Firmly grip the edger handle with your left hand, pulling the Start Lever against the handle. (See Figure 6)
NOTE: Engine will not start if the Start Lever is not pulled against the handle
5. Firmly grip the Recoil Starter Handle with your right
hand. (See Figure 6)
6. Pull the recoil slowly, until you feel tension in the starter rope. Then quickly pull the recoil starter handle
to completely unwind the starter rope. DO NOT allow
the starter rope to snap back. Let the starter rope slowly
rewind.
7. After the engine starts, wait
8. If engine fails to start after 5 or 6 more attempts, see instructions in the “Troubleshooting Chart”.
| Recoil |
|
|
| Starter |
| Depth |
| Handle |
| Control |
|
|
| Lever |
|
| Start | Figure 6 |
|
| Position | |
Questions? Call Toll Free at | 9 | Copyright © 2009 MAT Engine Technologies, LLC |