1.Read and understand the entire owner’s manual before attempting assembly or operation.
2.Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury.
3.Replace the warning labels if they become obscured or removed.
4.This rip saw is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a rip saw, do not use until proper training and knowledge have been obtained.
5.Do not use this rip saw for other than its intended use. If used for other purposes, Powermatic disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use. Your rip saw is provided with a 15HP main motor; do not equip your rip saw with a motor of higher horsepower.
6.Always wear approved safety glasses/face shields while using this rip saw. Everyday eyeglasses only have impact resistant lenses; they are not safety glasses.
7.Before operating the rip saw, remove tie, rings, watches and other jewelry, and roll sleeves up past the elbows. Remove all loose clothing and confine long hair.
8.Keep hands outside the machine. Never reach under the guards to try to clear stock that stops feeding.
9.Wear ear protectors (plugs or muffs) during extended periods of operation.
10.Some dust created by power sanding, sawing, grinding, drilling and other construction activities contain chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•Lead from lead based paint.
•Crystalline silica from bricks, cement and other masonry products.
•Arsenic and chromium from chemically treated lumber.
Your risk of exposure varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a
11.Do not operate this machine while tired or under the influence of drugs, alcohol or any medication.
12.Make certain the switch is in the OFF position before connecting the machine to the power supply.
13.Make certain the machine is properly grounded.
14.Make all machine adjustments or maintenance with the machine unplugged from the power source. A machine under repair should be red tagged to show that it should not be used until maintenance is complete.
15.Remove adjusting keys and wrenches. Form a habit of checking to see that keys and adjusting wrenches are removed from the machine before turning it on.
16.Keep safety guards in place at all times when the machine is in use. If removed for maintenance purposes, use extreme caution and replace the guards immediately.
17.Check damaged parts. Before further use of the machine, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced.
18.Provide for adequate space surrounding work area and
4
