|
| Preventive Maintenance |
|
| Checklist for Model SLR12 Straight Line Rip Saw |
[ | ] | Work area around machine marked off clearly. |
[ | ] | |
[ | ] | Inspect entire machine for loose bolts, nuts, screws. Tighten and replace as necessary. |
[ | ] | Clean table area, removing sawdust and chips with a soft bristle brush. Remove gum and pitch |
|
| with oven cleaner. |
[ | ] | Lubricate appropriate places with a good grade |
[ | ] | Clean table and fence surface. If rusted, use paste mixture of household ammonia, a good |
|
| commercial detergent and 000 steel wool. Wash surface down with hot, soapy water, rinse and |
|
| dry thoroughly. Coat surface with talcum powder, rubbing briskly into surface with a clean |
|
| blackboard eraser. |
[ | ] | Check blade condition; should be sharp and free of nicks or grooves. |
[ | ] | Check belt condition. Replace as needed. Dress with parafin. Check belt tension. |
[ | ] | Check motor for loose wiring and sawdust congestion, pulleys tight and in line. |
[ | ] | Check bearings. Replace any bad or suspect bearings immediately. |
[ | ] | Fence properly aligned with blade. |
427 New Sanford Road
LaVergne, TN 37086 Phone:
32
