(24 mm) apart.. Use a 1/8" (3 mm) drill bit for the supplied screws to mount the cup.. The third 1/4” (7 mm) hole is required for the wire to pass through..
Use the template provided to locate the hole centers.. Cut carpeting or fabric away from the hole locations to prevent tangling of fibers in the drill bit..
Surface mount (Straight or Angled)
Mounting slots (qty 4)
#6 x 3/4" screws (qty 2)
Insert two #6 x 3/4" flat head sheet metal screws through the holes in the bottom of the surface mount cup.. Screw the cup in place.. Ensure the mounting screws are driven in straight, so the heads sit flush on the cup mounting surface.. This ensures the tweeter will seat properly in the surface mounting cup.. The tweeter is then slid into the mounting cup (tabs aligned with the mounting slots), and turned counterclockwise to lock in place..
NOTE: The mounting cup is also supplied with an angled surface mounting cup (not shown).. This allows the tweeter to be mounted at an optimum acoustic angle for the listener.. Follow the same procedure as above to mount and assemble the tweeter in this housing..
Flush mount (Surface or Angled)
Note: Ensure that there is enough clearance within the interior door panel for the
Metal mounting bracket
Mounting slots (qty 4)
screws (qty 2)
Flush Angled
Mounting Cup
Check the intended installation site to be sure that there is sufficient depth behind the mounting surface for the rear cup and mounting screws.. The minimum depth required behind the back of the mounting surface is 1" (25 mm).. The front cup mounts into the mounting through a
Use the template provided to locate the hole centers.. Cut carpeting or fabric away
14
