Precision Power 356cs, 355cs manual Tweeter mounting

from the hole locations to prevent tangling of fibers in the saw blade..

Insert the two M4-0..7 X 4-1/2 cm (1..77 inches) flat head metal screws through the mounting holes and just start the threads into the metal mounting bracket.. With the metal bracket attached to the mounting cup slide one end of the metal bracket and then the other end into the mounting hole.. Hold the mounting cup in its final position and tighten, but do not over tighten the two mounting screws..

The tweeter is then slid into the mounting cup (tabs aligned with the mounting slots), and turned counterclockwise to lock in place..

NOTE: The mounting cup is also supplied with an angled surface mounting cup (not shown).. This allows the tweeter to be mounted at an optimum acoustic angle for the listener.. Follow the same procedure as above to mount and assemble the tweeter in this housing..

Tweeter mounting

Route the wire from the crossover locations to the tweeter locations.. Pull the wire through the wire hole and attach crossover wires to the wires from the tweeters.. Connect the positive wire to the positive (+) terminal of the tweeter, which is marked with the white trace.. See the information in the speaker wiring section of this manual and the wiring diagrams.. Push the wire back into the area behind the installation location and be sure it will not interfere with the speaker or with anything behind the mounting panel.. To attach the tweeter to the surface or flush mount assembly, align the tabs in the mounting cup with the relieved areas in the tweeter mount..

Mounting	Surface Mount Housing
Screws

Tweeter

TWEETER Tweeter

Wiring

PanelWiring

15