After all the connections and any necessary adjustments have been made snap the cover back in place..
connecting the system
Trim the speaker wire as needed.. Strip about 1/4" (6 mm) of the insulation from the ends.. Twist the exposed strands thoroughly to prevent any loose strands from causing a short circuit.. You may also "tin" the wire with a soldering iron.. The wires attach to a removable connector which in its assembled position has the screws facing the bottom of the crossover.. Insert the prepared wire into the appropriate location (see diagram or refer to the crossover circuit board) in the connector strip and tighten the screws to secure the wires in place.. Be sure to note the polarity marking on the circuit board..
18
