Unpacking the StretchTrainer
The StretchTrainer comes equipped with everything you need to assemble it. Refer to Diagram 2. It is shipped in the following pieces:
zSeat assembly (padded seat, knee pad, bolts and washers)
zbase rails (2)
zhandlebar (includes wrist straps)
zinstructional placard
•assembly kit
3mm and 6mm hex keys Two
Two foot rests
Two rear level adjustors (for the base rails) Seat bumper
Axle
Alignment bracket
Several fasteners (bolts, washers, and nuts)
zliterature kit - not shown in Diagram 2 (includes the assembly instructions and warranty card)
Carefully unpack the pieces and lay them on the floor near the location where you plan to use it. If any items are missing, contact the dealer from whom you purchased the StretchTrainer or use the Precor web site at www.precor.com to find the dealer nearest you.
Assembly Instructions
To assist you in the assembly of the StretchTrainer, refer to Diagram 2 while performing the following steps.
Important: Assemble and operate the StretchTrainer on a solid, level surface. Also, have rags or paper towels available to set the fasteners on during assembly. Be aware that the lubrication on the fasteners can stain carpeting and clothing.
Extra tools needed: A small crescent (or
1.Ask for assistance in assembling the StretchTrainer. Putting the seat assembly together and positioning it and the handlebars over the base rails is a difficult procedure for one person. Fully assembled, the StretchTrainer weighs over 60 pounds.
2.Set the base rails on the floor. Ask for an assistant to hold the upright supports together while you align and secure the base rails.
® |
| |
Diagram 2 |
| |
StretchTrainer parts. |
| |
| Instructional placard | |
| Handlebar | |
| Padded seat | |
Upright | Seat bumper | |
support | ||
Seat plate | ||
| ||
Wrist | Seat frame | |
straps |
| |
| Knee pad | |
| Foot rest | |
Seat bracket | Alignment bracket | |
| ||
| Base rails | |
| Rear level adjustor |
page 5
