| ® | |
13. Secure the axle. Diagram 10. Make sure that | Diagram 10 | |
the foot rests are securely fastened to the axle | Securing the axle. | |
and the axle is centered through the seat frame. |
| |
Use the 3mm hex key to tighten the two small | Tighten screw with | |
set screws that hold the axle in position. Do not | 3mm hex key | |
overtighten the screws. |
| |
14. Secure the handlebar. Diagram 11. Prior | Axle | |
| ||
to tightening the handlebar bolts, slide the |
| |
handlebar caps into the upright supports. | Foot rest | |
Then, securely tighten the bolts using the | ||
| ||
6mm hex key. |
|
15.Return to the seat bracket bolts. Use the hex key to securely tighten the 4 seat bracket bolts. Do not tighten the bolts so severely that you compress or crack the plastic alignment bracket.
16.Position the instructional placard onto the handlebar bracket. Diagram 12. Remove the paper backing from the
17.Center the placard on the handlebar bracket and press firmly into place. Diagram 13. Be sure that the placard is positioned in the center of the handlebar bracket before you press it firmly onto the
18.Install the rear level adjustors. Diagram 14. Raise the rear end of the equipment slightly off the floor and slide a rubber level adjustor onto one side of the rear base rail. Slide the other level adjustor onto the opposite base rail. Carefully lower the equipment onto the floor. Avoid pinching your fingers.
Important: If the equipment is placed on a slightly, uneven surface, rotating the rear level adjustors can help, but will not compensate for extremely uneven surfaces. The maximum height that you can compensate for using the rear level adjustors is about one quarter inch (6 mm).
Diagram 11
Sliding the handlebar caps into place.
Wrist strap
Handlebar cap
Upright support
Diagram 12 |
Exposing the adhesive |
tape. |
Paper backing |
Handlebar |
Handlebar Bracket |
Diagram 13
Attaching the placard.
Instructional placard 
Adhesive double- sided tape
Handlebar
page 8
