Assembling the AMT 19
Required Tools
#2 Phillips screwdriver
Rubber mallet
SAE standard socket set
Wire cutter
Two #1 Phillips screwdrivers
Torque wrench (calibrated in inch-pounds, and including
³₁₆-inch hex wrench bit)
Unpacking the AMT
DANGER
Do not attempt to connect electrical power until
all assembly procedures are complete and the
console is properly installed.
CAUTION: Do not climb onto the AMT until directed to do so.
Follow these steps to remove the AMT base unit from its
shipping container.
To unpack the AMT:
1. Remove the rear pedestal and set it aside.
2. Remove and discard the fastener securing the back of the
center support to the shipping pallet.
3. Remove and discard the bolts and nuts securing the
wooden supports to the side arms of the AMT.
4. Remove the fasteners securing the wooden supports to
the shipping pallet, then discard the supports and the
fasteners.
Important: In the following step, do not force the foam block
placed around the center support. Doing so may damage the
plastic cover on the center support. Instead, slide the foam
block backward until you have removed it from the plastic
cover, then lift it out of the way.
5. Cut and remove the plastic ties, bubble wrap, and foam
blocks securing the unmounted parts inside the shipping
container.