Precor P80 manual Attaching the Seat Back and Bottle Holder, To attach the seat back

16 Assembling and Maintaining RBK 800-Series Recumbent Exercise Bikes

Attaching the Seat Back and Bottle Holder

While the equipment is in use, the seat back flexes to support users of different shapes and sizes. Underneath the seat back, the bottle holder accommodates both left-handed and right-handed users.

To attach the seat back:

1.Insert the lower front edge of the seat back assembly under the seat.

2.Swing the seat back assembly into place so that its four screw holes line up with the holes on the seat carriage bracket, as shown in the following illustration.

Figure 2: Moving the seat back assembly into position

3.Place four ⁵₁₆-inch washers onto four ⁵₁₆-inch x ³₄-inch sockethead screws.

4.Insert the screws through the holes in the seat back assembly and thread them into the seat carriage bracket.

5.Adjust the position of the seat back, then tighten the screws completely using a ¹₄-inch hex wrench.