Precor P80 manual To thread the cable assembly

24 Assembling and Maintaining RBK 800-Series Recumbent Exercise Bikes

Important: Before you begin the following procedure, remove the rear cover from the control console. To remove the cover, use your fingernails to pry the lower edge loose, then swing the cover up and out as shown in the following illustration.

Figure 8: Removing the access cover from the P80 console

To thread the cable assembly:

1.Make sure that as much of each cable as possible passes through the opening in the middle of the console mount on the base unit.

2.Position the console over the console mount.

3.Rest the console on the console mount so that the notch on the bottom of the console’s back plate rests on the rectangular hook at the bottom of the console mount, as shown in the following figure.

Figure 9: Console positioning on base unit

4.Tilt the console forward until it stops. Use one hand to steady the console in this position, or ask your assistant to do so.