Precor P80 Completing the Console Installation P30 and P10, To complete the installation, Cable

46	Assembling and Maintaining TRM 800-Series Treadmills
	Table 3. P30 and P10 internal cable connections
	Cable	Connector Type	Circuit
			Connector
			Location
	Safety key (treadmills	Six-contact strip, keyed
	only)
	Automatic stop sensor	Four-contact strip,
	(treadmills only)	keyed
	Data from base unit	Eight-contact modular,
		on flat gray cable
	Heart rate sensors	Four-contact strip,
		keyed
	CSAFE	Eight-contact modular,
		on flat gray cable

Completing the Console Installation (P30 and P10)

Before you complete the final installation steps, double-check the connections you have made. Make sure that all cables are fully and securely connected, and that any unneeded cables are tied back properly.

To complete the installation:

1.Feed extra cable back into the neck tube.

2.Tilt the control console backward (toward yourself) until the tab on the top edge of its back plate slides along the top edge of the console mount and the screw holes align properly.

3.Insert the four ⁵₈-inch flat head screws through the holes in the console mount and thread them into the holes in the back plate on the console. Partially tighten the screws using a ⁵₃₂-inch hex wrench.