Precor P80 manual Leveling the EFX, To level the unit

Assembling the EFX 31

5.Slide the covers down and snap them into the base mount.

Note: Be sure to align the covers so that the lip of each cover fits inside the edge of the base mount and the hook on the base mount fits into the corresponding slot on the cover. When you have snapped the covers into place, the surfaces of the covers and the base mount should line up smoothly.

6.Repeat steps 1 through 5 to attach the other pair of upright support covers.

Leveling the EFX

Make sure the unit is level before allowing anyone to use it.

CAUTION: To eliminate movement, make sure the adjustable feet are in contact with the floor.

To level the unit:

1.Gently rock the unit. If there is any movement, ask your assistant to tip the unit to one side while you locate the adjustable feet.

2.Correct the height of each adjustable foot as follows.

If you want to …	Then turn the adjustable feet …
Raise the unit	Counterclockwise
Lower the unit	Clockwise

Figure 21: Rubber pad and adjustable foot locations

Important: Place the unit on a flat surface. Rotating the adjustable feet cannot compensate for extremely uneven surfaces.

When you are finished adjusting the unit, place the unit on the floor and recheck that it is level.