Securing the Plate
Adjust and Tighten
Wing Nut
M5 x 16mm Set
Screw
Tiles
Step 1. Position and slide the adapter plate to the hole and secure the ceiling plate to the rails by tightening the four (4) M5 x 16mm Phillips head screws.
Step 2. Center the stud plate to the hole and secure the plate by tightening the four wing nuts..
Electrical Box Installation
Electrical installation should be done in accordance to local codes and regulations.
Step 1. Cut the tile where the electrical base box is going to be secured.
Step 2. Using (commercially available) hardware depending on electrical installation environment, install the electrical box and secure it to the plate.
Step 3. Make all electrical connections at this time.
CUT
Electrical Box
Installation Instructions | Page 5 |