RFM
Concrete Mounting
Concrete anchors must be used for concrete installation. They can be purchased at your local hardware store. The mounting surface must be a minimum 6” thick.
1.Begin by placing the mount into position against the wall, keeping it level.
2.Mark off four holes to be used for securing the mount.
3.Next, drill holes using a masonry bit for your anchors (recommended masonry bit).
4.Insert a commercially available concrete anchor into each hole (recommended 3/8” wedge anchors).
5.If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall.
6.Once all of the anchors are in place, move the wall bracket into position.
7.Attach the nut onto the threaded shaft that is protruding from the wall.
8.Do not tighten until all nuts are in place.
Universal Mounting Bracket Assembly
1.Place the universal bracket bar and the universal brackets on a flat surface.
2.Slide the universal brackets onto the universal bracket bar (as shown below) with the set screws facing up. At this time, do not tighten the set screws that are located on the universal bracket.
3.Place the display on a soft, flat surface,
4.Once the desired position has been determined, place the Griplate™ washers over each mounting point and secure them using the appropriate hardware (see Page 5).
For the two upper mounting points, the Griplate™ flat side must be facing up. For the two lower mounting points, the Griplate™ flat side must be facing down.
5.At this time, center the universal bracket bar and tighten the set screws that are located on the universal brackets.
M5 M8
Universal Mounting Brackets
M4 M6
Set Screw
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Griplate™ | Universal Bracket Bar | Griplate™ | |||
IT WILL TAKE TWO PEOPLE TO COMPLETE THE NEXT INSTALLATION STEP.
Page 8 | Installation Instructions |
