USA
Installing the Display on the Support Tubes
WARNING: THE FOLLOWING STEPS MUST BE PERFORMED USING THREE PEOPLE. FAILURE TO DO SO WILL RESULT IN PHYSICAL DAMAGE TO THE DISPLAY AND/OR THE PERSONNEL PERFORMING THESE STEPS.
1. | Two people, one on each side, must pick up the display. | NOTE: In some cases, the support tubes will not voluntarily |
2. | Align the upper USA mounting bracket above the two | align with the upper USA mounting bracket. In these |
| support tubes and lower the unit down. | cases, the third person must squeeze, or spread, the |
|
| support tubes together. Once the holes and the support |
|
| tubes are aligned, lower the unit onto the support tubes. |
Set Screw | 5/32” Allen Wrench |
3.After the appropriate height has been determined, use the 5/32” Allen wrench (supplied) to tighten the two set screws on each side of the mounting bracket.
Attaching the Lower USA Mounting Bracket
1.Lift the lower USA mounting bracket until it is even with the display.
|
| Mounting Point |
Mounting Point |
| |
|
|
|
|
|
|
2.Line up the lower USA mounting bracket with the mounting points that are located on the back of the display.
Installation Instructions | Page 7 |