Samsung SMX-C200BP/EDC manual recording, Recording Videos, Press the Recording start/stop button

recording

Basic procedures to record a videos or photos are described below and on the following pages.

RECORDING VIDEOS

The camcorder provides two Recording start/stop buttons. One is on the rear side of the camcorder and the other one is on the LCD panel. Select the one that works best for you.

1.Open the LCD screen and press the Power button to turn on the

camcorder.	0:00:00 [475Min]
• Connect a power source to the camcorder. ²page 15
(A battery pack or an AC power adaptor)

•Set the appropriate storage media. ²page 30 (SMX-C24 only) (If you want to record on a memory card, insert the memory card.)

2.Check the subject on the LCD screen.

3.Press the Recording start/stop button.

•The recording indicator ( ) will display and recording will start.

•To stop recording, press the Recording start/stop button again.

4.When recording is finished, turn the camcorder off.

•Samsung is not responsible for any loss or damages due to the memory card problem such as saving failures and abnormal playbacks.

•Beware that you can not recover a damaged recorded data.

•Do not disconnect the power source (battery pack, AC adaptor) during a recording. Otherwise, it may cause damage to the storage media or data corruption.

• For on-screen information display. ²page 21

•Eject the battery pack when you have finished recording to prevent unnecessary battery power consumption.

•For various functions available when you record videos. ²pages 45~58

•During recording, some button operations are unavailable. (Mode button, MENU button, etc.)

•Sound is recorded from the internal stereo microphone on the front of the camcorder. Take care that this microphone is not blocked.

•Before recording an important video, make sure to test the recording function to check if there is any problem with the audio and video recording.

•Do not operate the Power button or remove the memory card while accessing the storage media. Doing so may damage the storage media or the data on the storage media.

•LCD screen brightness and colour can be adjusted from the menu. Adjusting the brightness or colour of the LCD screen does not affect the image to be recorded. ²page 77

•This camcorder provides one combined video and photo record mode.

You can easily record videos or photos in the same mode without having to change it.

•You cannot use a locked memory card for recording. You will see a message saying recording is disabled due to the lock.

•You can switch the play mode to the record mode by pressing the Recording start/stop or Mode button.

•If the power cable/battery is disconnected or recording is disabled during recording, the system is

switched to the data recovery mode. While data is being recovered, no other function is enabled.

After data recovery, the system will be switched to the STBY mode. When the recording time is short, 35 the data recovery might fail.