Samsung SMX-C200RP/EDC Important information on use, Before using this camcorder, Important notes

Important information on use

Before using this camcorder

•This camcorder is designed exclusively for use with the high-capacity built-in flash memory 16GB (SMX-C24 only) and an external memory card.

•This camcorder records video in H.264/ AVC (MPEG4 part 10/Advanced Video Coding) format compliant with the Standard resolution (SD-VIDEO) format.

•Please note that this camcorder is not compatible with other digital video formats.

•Before recording important video, make a trial recording.

-Play back your trial recording to make sure the video and audio have been recorded properly.

•The recorded contents cannot be compensated for:

-Samsung cannot compensate for any damages caused when recording is not made normally or recorded contents cannot be played back because of a de- fect in the camcorder or memory card. Also, Samsung cannot be held respon- sible for your recorded video and audio.

-Recorded contents may be lost due to an error when handling this camcorder or memory card, etc. Samsung shall not be held responsible for the loss of recorded contents, and cannot compensate for any damages.

•Make a backup of important recorded data.

-Protect your important recorded data by copying the files to a PC. We recommend copying the data to your PC or other recording media for storage. Refer to the software installation and USB connection guide.

•Copyright: Please note that this camcorder is intended for consumer use only.

-Data recorded on a card in this camcorder from other digital/analogue media or devices is protected by the copyright act and cannot be used without permission of

the copyright owner except for personal enjoyment. Even if you record an event such as a show, performance or exhibition for personal enjoyment, it is strongly recommended that you obtain permission beforehand.

Important notes

•Handle the liquid crystal display (LCD) with care:

-The LCD is a very delicate display device: Do not press its surface with excessive force, hit it or prick it with a sharp object.

-If you push the LCD surface, display unevenness may occur. If unevenness does not disappear, turn the camcorder off, wait for a few moments, and then turn it on again.

-Do not place the camcorder with the open LCD screen down.

-Close the LCD monitor when not using the camcorder.

•Liquid crystal display:

-The LCD screen is a product of high precision technology. Out of the total pixels (approx. 230,000 pixels of an LCD monitor ), 0.01% or less pixels may be out (black dots) or may remain lit as coloured dots (red, blue, and green). This shows the limitations of the current technology, and does not indicate a fault that will interfere with recording.

-The LCD screen will be slightly dimmer than usual when the camcorder is at low temperature, as in cold areas, or right after the power is turned on. Normal brightness will be restored when the temperature inside the camcorder rises. Note that this will have no effect on the image in a storage media, so there is no cause for concern.

•Hold the camcorder correctly:

-Do not hold the camcorder by the LCD

monitor when lifting it: the LCD monitor	v
could detach and the camcorder may fall.