Using Network Functions (IN2114 & IN2116 only)
IMPORTANT: To enable network functions at all times (even when the pro- jector is powered off), the Network item in the
Projector network functions include:
•Configuring and controlling the projector via a web browser.
•Failure and warning alerts via email.
•Projector Management via SNMP.
•Controlling the projector via Scheduling.
NOTE: Projector web pages and emails sent by the projector are always dis- played in English language.
Before using the network functions
To use the network functions of the projector, the projector must be config- ured to suit your network. Consult with your network administrator before connecting the projector to your network; incorrect network configuration of the projector may cause problems on your network.
Connect the Network Cable
Properly connect projector to the network, then configure the following set- tings.
If Using a Network with DHCP Enabled:
1Use the projector's remote control or keypad to select the Network item in the projector's Setup menu.
2If DHCP is off, select it to turn it on.
If Using a Network that Does Not have DHCP Enabled:
1Use the projector's remote control or keypad to select the Network item in the projector's Setup menu.
2If DHCP is on, select it to turn it off.
NOTE: If you still don’t see an IP address, go to the projector’s Setup menu, select Network, then turn on Show Network Messages. After exiting the menu press the Source button again.
3Select IP Address. This will highlight the first of the four octets in the IP address. Press Up or Down to change the value, then press Select or Right when done to move to the next octet. Repeat until you have changed all four octets in the IP address.
4Repeat the above for Subnet Mask, Default Gateway, and other settings that are in IP address format (to assign or change the Host Name, see
Network Settings Page below).
Configuring and Controlling the Projector via a Web Browser
You can adjust or control the projector via a network from a web browser on a computer that is connected to the same network as the projector.
NOTES:
•To access the projector’s web pages, the projector must be connected to the network and connected to AC power (and if you want to access the web pages even when the projector is powered off, make sure that the Network item in the
•JavaScript must be enabled in your browser to use the projector web pages properly. If JavaScript is disabled, see the Help files for your web browser for details on how to enable it.
•If no operations are performed in the web browser for approximately ten minutes, the system will automatically log you off.
Logging in
To log into the projector web pages, follow these steps:
1Make sure the projector is connected to the network and connected to AC power.
2If you don't know the projector's IP address, turn on the projector. After the projector starts up, if its IP address is not
shown, press the Source button to view the IP address.
33
