XL6000CM
Attaching the Projector
NOTE: Please follow the installation sheet included with the specific mounting bracket for your projector. Once the mounting bracket has been secured to the projector, follow the instructions below.
1.Raise the projector (with the mounting bracket attached) and hook the projector bracket over the hinge screws (Figure 4).
CAUTION: Make sure the bracket is fully secured to the Base Box before letting go of the projector.
2.Loosely install the two (2) M6 x 12mm Phillips Head Hinge screws, flat washers and nylon spacers into the hinge holes, located on each side of the base box (Figure 4). DO NOT TIGHTEN THESE SCREWS!
3.Once the mount is safely attached, insert and tighten the four (4) M6 x 12mm Phillips Head Screw (Figure 4).
4.Once all adjustments have been made, tighten all hardware.
Hinge Screw Hole
Nylon Spacer
Set Screw ( NOTE: Use set screw only when attaching to pipe).
M6 x 12mm Phillips Head Screws (Attach after the bracket has been mounted and tightened)
Projector
Bracket
M6 x 12mm
Phillips Head
Hinge Screw
Figure 4
Adjusting the Projector
1.You can adjust the roll of the projector by loosening the three (3) front and rear M6 x 12mm screws (Figure 5).
Do not fully loosen the screws, as the mount may drop.
2. Set the desired roll and then tighten the screws. First tighten the center screws and work your way to the outside screws, making any final adjustments prior to tightening the last two screws.
3. You can adjust the tilt of the projector by loosening the two (2) M6 x 12mm screws on each side of the Base Box (Figure 5).
4.Set the desired tilt and then tighten the screws, making
any final adjustments prior to tightening the last two screws.
If your projector is not holding the tilt, install the four (4) internal/external tooth lock washers to the four (4) M6 x 12mm tilt screws.
5. Once all adjustments have been made, tighten all hardware.
Roll
Tilt
Installation Instructions | Page 5 |
