Presonus Audio electronic Microphone Preamplifier Master Output Section, FireControl Mixer

CONTROLS AND CONNECTIONS

Master Output Section

• Master Output Fader	Changes the selected output’s audio level
	Move the Master Fader up and down to increase and
	decrease the level of the selected output’s audio.
	The dB value of boost or attenuation is displayed below the
	Channel Fader from –infinity to 0.0 dB.
	Two virtual LED meters to the right of the Master Fader
	display the pre fader levels of the audio signal.
	The peak value in dBFS of the channel’s audio is displayed
	directly above the Master Output’s virtual LED meter.
	NOTE: If the peak values display “CLIP”, then your
	Mixer channels and/or your DAW playback levels
	should be reduced. The clip indicators clear when
	the mouse pointer hovers over them.
• Master Mute and Solo Clear
	Clears all active channel Mutes or Solos
	The Master Mute and Solo clear buttons are only active
	when a channel’s mute or solo button is active.

3.1.3 FireControl Mixer

The FireControl Mixer allows you to create a customized mix of up to 18 of the FireStudio Project’s hardware inputs and software playback outputs and adjust their levels independently for each of the FireStudio Project’s stereo output pairs with zero latency. The Mixer section is only visible if the selected output pair’s Mixer Toggle is on.

NOTE: The Mixer is common to all of the FireStudio Project’s outputs, so if you add or remove a channel from the Mixer, every output with the Mixer Toggle on will be affected by the change.

18 PreSonus 2007