V I I . C A R E A N D M A I N T E N A N C E
3.Release the seat friction lock lever and rotate the seat
4.Turn the rear shroud fasteners
5.Remove the rear shroud.
6.Unplug the controller from the power base.
7.Remove the seat.
8.Turn the yellow fastener
9.Disconnect the battery harness from the rear battery. See figure 27.
10.Remove the rear battery.
11.Place a new battery in the power base.
12.Connect the battery harness to the rear battery according to the battery wiring diagram. See figure 29.
13.Remove the foot platform retaining pin and lift off the front cover. See figures 6 and 18.
14.Pull out the front battery tray.
15.Disconnect the battery harness from the front battery.
16.Unfasten the battery strap.
17.Remove the front battery.
18.Place a new battery onto the battery tray.
19.Connect the battery harness to the front battery according to the battery wiring diagram.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
20.Fasten the battery strap.
21.Reinstall the center shroud.
22.Reinstall the front cover.
23.Reinstall the seat. Rotate it
24.Plug in the controller to the power base.
25.Reinstall the rear shroud.
26.Rotate the seat forward.
27.Charge the batteries. See VI. “Batteries and Charging.”
When to See Your Authorized Pride Provider for Service
The following symptoms could indicate a serious problem with your power chair. If necessary, contact your authorized Pride Provider. When calling, have the model number, serial number, nature of the problem, and the error code if available.
!Motor noise
!Frayed harnesses
!Cracked or broken connectors
!Uneven wear on any of the tires
!Jerky motion
!Pulling to one side
!Bent or broken wheel assemblies
!Does not power up
!Powers up, but does not move
44 | www.pridemobility.com | Jazzy 1143 Ultra |