Pride Mobility 1143 manual Multi-Axis Foot Plates, Power Elevating Seat System Standard

	V . C O M F O R T A D J U S T M E N T S
Multi-Axis Foot Plates
The multi-axis foot plate assembly can be installed on either
a swing-away footrest or an elevating leg rest. The multi-
axis foot plate has four adjustments: leg rest length (A), po-
sition (B), tilt (C), and angle (D). See figure 24.
To change leg rest length (A):
1.	Remove the hardware.
2.	Move the leg rest to the desired position.	A
		B
3.	Reinstall the hardware.
To change foot plate position (B):			C
1.	Remove the hardware.
2.	Move the foot plate to the desired position.	D
3.	Reinstall the hardware.
To change foot plate tilt (C):
1.	Loosen the hardware.
2.	Tilt the foot plate to desired position.	A
3.	Tighten the hardware.
To change foot plate angle (D):
1.	Turn the setscrew clockwise to decrease the angle.
2.	Turn the setscrew counterclockwise to increase the
	angle.
		B
Power Elevating Seat System (Standard)
The power elevating seat system is equipped with a power
elevating seat actuator that enables you to raise and lower the
seat automatically. See figure 25. The power elevating seat
system can enhance the capabilities of the power chair sev-
eral ways:		C
!	By raising the seat, you extend your level of reach to allow
	morefreedomandindependenceinmanyenvironments.
! Byraisingorloweringtheseat,youcaneasilyadjusttheseat
	height to any surface to which you want totransfer. .
! Byraisingtheseat,youareclosertotheeyelevelofstanding
	persons.Thisprovidesbetterinteraction.
		D
For all the benefits your power elevating seat system can
provide you, there are limitations. Observe the following
precautions in order to ensure safe use of the power elevat-
ing seat system.
		SETSCREWS
		Figure 24. Multi-Axis Foot Plate (ELR Shown)

32 www.pridemobility.com Jazzy 1143 Ultra